Of you want to ping multiple hosts i.e. IP addresses at in parallel and then try this PowerShell  script. This script will create an output file either .txt or .csv format.

Do you need to reset your GPS admin password?

If you forgot the admin password, then send the following SMS command to the tracker number.

RCONF

Note this command is not CsSE sensitive. You can send, rconf or RConf.

Sino GPS Tracker (model: ST-903, ST-904, ST-905, ST-915 and ST-925) LED Indicator Light Status and its meaning

Yellow lightOn GPRS connection

Yellow light (Flashing)No GPRS signal

Blue lightOn GPS connection

Blue light (Flashing)No GPS signal

Red lightOn Tracker is Charging

Red light – OffTracker is not Charging

Sino GPS Tracker LED Status

You can set three authorise mobile numbers that can control your Sino GPS trackers (model: ST-905, ST-906, ST-915 and ST-925). Set an admin, i.e. control number, send this SMS command:

Number+pass+blank+serial
Sample: 04001234560000 1
Where, 0400123456 is your mobile number, 0000 is password, 1 refers to the first admin/control number.
When the tracker reply “SET OK” means the setting is ok.

If you forgot yout TKSTAR (TK905B) GPS tracker password and want to reset it then follow these steps.

To reboot /restart the GPS tracker, send this SMS command to the tracker number. RST

The tracker will immediately restart!

Now, send this SMS command to the tracker number: format

Configure Sino GPS Tracker (model: ST-903, ST-904, ST-905, ST-915 and ST-925)

To get the current location of the tracker send this SMS command to the tracker number: 6690000

Command format: 669password. There, 0000 is the GPS tracker factory default password.

To set an Admin number (after admin number setting, all SMS operations to the device are under this admin (i.e. authorised) number only.)
Send the following SMS command to the tracker number.

admin123456+SPACE+your_phone_number

Please note, 123456 is the factory default password of your tracker.

An example: admin123456 13265790180

AT+COPS?

AT+CGMI

Telit

OK

AT+CGMM

AT+CGMR

AT+GCAP

+GCAP:+FCLASS,+CGSM

AT+CSQ -- Signal level

He who controls the exit nodes, controls the traffic.Mr. Robot, Elliot confronts the owner of Ron's Coffee. 

Tor exit nodes are the last “hops” that Tor network traffic goes through when making a circuit around it.

There is someone who operates each of the nodes on Tor (usually independent volunteers). However, some of these are operated by law enforcement agencies (like the NSA, for instance), or by other individuals who have the intent of spying on Tor traffic.

TO find out the BIOS version in Linux, execute this command dmidecode | less

To check BIOS firmware version in Linux, use this command: sudo dmidecode -s bios-version

sudo dmidecode --type bios

To verify whether a Linux instance is enabled for UEFI Secure Boot

mokutil --sb-state

Virtual Machine secure boot: